6 V6-3.0L DOHC (2003)
56.
Reconnect the gray and black connectors.
57.
Reconnect the negative battery cable.
58.
Turn the ignition to the "ON" position.
59.
Fuel the vehicle until the fuel gauge reads between 1/4 and 1/2,
NOTE:
The fuel level must not be more than 1/2 to run the WDS EVAP test.
60.
Crank the engine until it starts and ensure there is no fuel leakage at the fuel line.
61.
Turn the engine off.
62.
Perform EVAP test using WDS.
^
If the vehicle passes the WDS EVAP test, proceed to the next step.
^
If the vehicle fails the WDS EVAP test, repeat "D. REPAIR PROCEDURE (Replacement of Fuel Tank, Fuel Pump Lock Ring & Fuel Pump
Seal)" beginning with Step 29. It is not necessary to replace the fuel pump lock ring and fuel pump seal again.
63.
Reinstall the fuel pump access cover.
64.
Reinstall the seat bottom.
NOTE:
Prior to installing the seat bottom, feed all seat belts through bottom of seat cushion.
65.
Reprogram all of the customer's preset radio stations.
66.
Proceed to "E. AUTHORIZED MODIFICATION LABEL INSTALLATION."
67.
Return the vehicle to the customer.
