6 V6-3.7L (2009)
Antenna Cable: All Technical Service Bulletins
Lighting - Water In Rear Combination Lamps
Bulletin No.: 09-028/08
Last Issued: 9/16/2008
Subject:
WATER IN COMBINATION LIGHT - IMPROPER SATELLITE RADIO ANTENNA CABLE ROUTING
APPLICABLE MODEL(S)/VINS
2009 Mazda6
2005-2008 RX-8 vehicles with VIN JM1 FE**** 50 143221 and higher
(produced August 1, 2004 and later)
2009 RX-8
DESCRIPTION
During installation of the SAT audio accessory, special attention is required when routing the antenna harness through the combination light opening in
the vehicle body, and proper placement of pad protectors / butyl tape. Improper routing / placement of protector pads / butyl tape may result in water /
condensation inside the combination light. Please refer to the following diagrams for proper antenna cable routing.
REPAIR PROCEDURE
NOTE:
^
Re-routing of antenna cable, labor for drying combination lights and/or replacement of combination lights due to water entry /
condensation as a result of improper antenna cable routing are not warrantable repairs.
1.
Verify customer concern.
2.
On RX-8 vehicles, remove the Left rear combination light. On Mazda6 vehicles, remove the Right rear combination light.
-
2005-2008 RX-8 - Refer to MS3 repair information or Workshop Manual section 09-18 - REAR COMBINATION LIGHT
REMOVAL/INSTALLATION.
-
2009 RX-8 - Refer to MS3 repair information or Workshop Manual section 09-18 - REAR COMBINATION LIGHT
REMOVAL/INSTALLATION.
-
2009 Mazda6 - Refer to MS3 repair information or Workshop Manual section 09-18
-
REAR COMBINATION LIGHT REMOVAL/INSTALLATION.
