6 V6-3.7L (2009)
Keyless Entry Module: Service and Repair
Keyless Control Module Removal/Installation [Advanced Keyless Entry And Push Button Start
System]
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
1. If the keyless control module is replaced, always perform the following procedure.
-
Vehicles with immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
[Advanced Keyless Entry And Push Button Start System]
-
Immobilizer System-related Parts Programming [No.4 Programming Procedure Due to Keyless Control Module Replacement] See:
Testing and Inspection/Programming and Relearning/Immobilizer System-Related Parts Programming [Advanced Keyless Entry And Push
Button Start System]
-
Vehicles without immobilizer system
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
[Advanced Keyless Entry And Push Button Start System]
-
Advanced Key Id Code Registration See: Testing and Inspection/Programming and Relearning/Advanced Key ID Code Registration
[Advanced Keyless Entry And Push Button Start System]
-
Steering Lock Unit Id Code Registration See: Testing and Inspection/Programming and Relearning/Steering Lock Unit ID Code
Registration [Advanced Keyless Entry And Push Button Start System]
2. Disconnect the negative battery cable.
3. Remove the front scuff plate. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate
Removal/Installation
4. Remove the front side trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
