6 V6-3.7L (2009)
g. Install new receiver.
h. Bind short cord and affix to vehicle harness with tie-wrap (A).
NOTE:Make sure that bound short cord is placed deep inside glove box to avoid interference.
I.
Cut tie-wrap (A) making sure that only 1-2 mm is left from tightened portion.
8. Reconnect negative battery cable.
9. Verify transmitter works properly to lock/unlock doors.
10. Install glove compartment and upper center panel.
11. Using a small flat screwdriver, push tab (A) lightly and separate original transmitter and key.
CAUTION:Be careful, the tab can be easily broken if pushed too hard.
12. Install separated key to new transmitter.
13. Insert Declaration of Conformity" leaflet into customer's Owners Manual.
NOTE:The Declaration of Conformity" leaflet contains certification to local radio acts (regulations).
14. Re-enter customer's preset radio stations.
15. Perform Power Window Initialization Procedure".
16. Verify repair.
PART(S) INFORMATION
NOTE:
WARRANTY INFORMATION
NOTE:
^
This warranty information applies only to verified customer complaints on vehicles eligible for warranty repair.
^
This repair will be covered under Mazda's New Vehicle Limited Warranty term. Additional diagnostic time cannot be claimed for this repair.
