6 V6-3.7L (2009)
6. *Slowly return driver's outer handle to 10mm (0.4 in.) mark.*
7. Check if thickness gauge can be moved freely.
-
* If gauge is stuck and force is required to remove it, outer handle is "Suspect", document outer handle type (Standard Keyless Entry or Advanced
Keyless Entry) on "Door Handle Inspection Results Sheet". Proceed to Step 8.*
-
If gauge is not stuck, outer handle is "Good". Proceed to Step 8.
8. Remove thickness gauge and slowly return outer handle.
9. Pull outer handle to full open position again and return with fingers firmly on outer handle. Ensure there is no sticking feeling.
-
If driver's outer handle does not stick, outer handle passes inspection. Proceed to "C. OUTER HANDLE REMOVAL" to remove the other three
(3) outer handles.
-
If driver's outer handle does stick, remove outer handle according to Workshop Manual (section 09-14 FRONT OUTER HANDLE
REMOVAL/INSTALLATION). After driver's outer handle removal, proceed to "C. OUTER HANDLE REMOVAL" to remove the other three
(3) outer handles.
C. - Outer Handle Removal
C. OUTER HANDLE REMOVAL
Updated information is shown with asterisks.
Outer Handle Removal for Inspection (front passenger and rear doors only).
1. Remove hole cover.
