6 V6-3.7L (2009)
Front Door Handle Switch: Testing and Inspection
REQUEST SWITCH INSPECTION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the
front beltline molding is approx. 80 mm {3.1 in}.
2. Disconnect the negative battery cable.
3. Remove the following parts:
a. Inner garnish See: Front Door Panel/Service and Repair/Removal and Replacement/Inner Garnish Removal/Installation
b. Front door trim See: Front Door Panel/Service and Repair/Removal and Replacement/Front Door Trim Removal/Installation
c. Front door speaker See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Speaker/Service and Repair/Front Door
Speaker Removal/Installation
d. Front door glass See: Front Door Window Glass/Service and Repair
e. Front door module panel See: Service and Repair/Front Door Module Panel Removal/Installation
f.
Front door key cylinder (Driver's side) See: Locks/Door Locks/Door Lock Cylinder/Service and Repair
g. Front outer handle See: Front Door Exterior Handle/Service and Repair
4. Verify the continuity of request switch terminals A and D.
5. Verify that the continuity is as indicated in the table.
-
If not as indicated in the table, replace the front outer handle.
