6 V6-3.7L (2009)
Repair Procedure
1.
Inspect driver's door glass run channel for damage, deformation, or mis-installation and repair as necessary. Proceed to Step 2.
2.
Remove glass run channel from upper rear corner of door.
3.
Remove white tape (if attached) on sash and discard.
4.
Confirm position of existing foam pad.
5.
Inspect for possible gap between foam pad and lip.
-
If a gap exists between foam pad and lip, peel off foam pad and discard. Proceed to Step 6.
-
If a gap does not exist between foam pad and lip, leave foam pad in place and proceed to Step 7.
NOTE:
^
Be sure to remove foam pad completely, including residue, otherwise wind noise may worsen.
