6 V6-3.7L (2009)
Technical Service Bulletin # 0903708
Date: 081023
Campaign MSP19 - B-Pillar Wind Noise
Bulletin: 09-037/08
Last Issued: 10/23/2008
Subject:
MAZDA SERVICE PROGRAM (MSP19) - WIND NOISE FROM DRIVER SIDE DOOR
APPLICABLE MODEL(S)/VINS
2009 MAZDA6 vehicles produced on or before August 13, 2008
DESCRIPTION
Some vehicles may experience excessive wind noise from the driver side door sash/B-pillar area. This may be caused by sash or window channel being
built out of specification.
NOTE:
^
UNDER THE MAZDA SERVICE PROGRAM (MSP19), ALL CURRENT DEALER INVENTORY AND RETAILED VEHICLES FOUND
TO BE PRODUCED ON OR BEFORE AUGUST 13, 2008, MUST BE INSPECTED AND REPAIRED ACCORDING TO THE
INSTRUCTIONS CONTAINED IN THIS SERVICE BULLETIN.
^
BEFORE PERFORMING ANY REPAIR, VALIDATE THAT THE VEHICLE IS APPLICABLE TO THIS PROGRAM BY PERFORMING
AN "eMDCS WARRANTY VEHICLE INQUIRY" AND VERIFYING THE VEHICLE DISPLAYS CAMPAIGN "MSP19" AND ITS
CAMPAIGN STATUS DISPLAYS "OPEN". SEE "VEHICLE INSPECTION PROCEDURE" BELOW.
DEALER INVENTORY:
Inspect and repair if necessary, all applicable vehicles currently in dealer inventory according to the procedures contained in this service bulletin.
RETAIL VEHICLES:
When an applicable retail vehicle is brought into the dealer for any type of repair or scheduled maintenance, perform an eMDCS Warranty Vehicle
Inspection and check the status of MSP19. If status of MSP19 is "OPEN" inspect and repair if necessary, the vehicle according to the procedures
contained in this service bulletin.
VEHICLE INSPECTION PROCEDURE
1.
Verify 2009 MAZDA6 vehicle was produced on or before August 13, 2008:
-
If the vehicle was not produced on or before August 13, 2008, do not repair using this repair procedure. If excessive wind noise is observed,
perform normal diagnostics before returning the vehicle to the customer or dealer inventory.
-
If the vehicle was produced on or before August 13, 2008, proceed to Step 2.
