6 V6-3.7L (2009)
NOTE:
Be careful not to insert or hold outer handle at an angle, otherwise, it could bind and lead to a false failure.
2. Slide the SST across the narrow area of the outer handle.
3. Slide the SST end-to-end (full stroke) over the entire surface of the outer handle.
-
If the outer handle does not fit into the SST, it fails the inspection.
-
*If the outer handle fits, but does not slide through the SST, it fails the inspection.*
-
*If the outer handle fails inspection, document outer handle type (Standard Keyless Entry or Advanced Keyless Entry) and location (LF, RF, LR,
RR) on "Door Handle Inspection Results Sheet". Proceed to "E.REPAIR PROCEDURE".*
-
*If the outer handle fits and slides through SST, it passes inspection, proceed to "Handle Bracket Inspection" to check handle bracket with male
end of SST.*
Handle Bracket Inspection:
