6 V6-3.7L (2009)
Rear Door Window Motor: Testing and Inspection
POWER WINDOW MOTOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the inner garnish. See: Front Door/Front Door Panel/Service and Repair/Removal and Replacement/Inner Garnish Removal/Installation
3. Remove the front door trim. See: Front Door/Front Door Panel/Service and Repair/Removal and Replacement/Front Door Trim
Removal/Installation
4. Remove the rear door trim. See: Rear Door Panel/Service and Repair/Removal and Replacement
5. Disconnect the power window motor connector.
6. Apply battery positive voltage and connect the ground to power window motor terminals E and F, and then inspect the power window motor
operation.
-
If the power window motor does not operate as indicated in the table, replace it.
7. Connect the battery positive voltage to power window motor terminal D and connect terminal C to ground.
8. Operate the power window motor and measure the voltage at terminals A and B.
-
If there is any malfunction, replace the power window motor.
Voltage
-
Pulse: max. 5 V/min. 0 V
