6 V6-3.7L (2009)
Power Trunk / Liftgate Lock Actuator: Testing and Inspection
Trunk Lid Release Actuator Inspection
TRUNK LID RELEASE ACTUATOR INSPECTION
1. Disconnect the negative battery cable.
2. Remove the recess. See: Interior Moulding / Trim/Trim Panel/Service and Repair/Recess Removal/Installation
3. Remove the trunk lid trim.
4. Remove the trunk lid latch and release actuator. See: Trunk / Liftgate Latch/Service and Repair
5. Apply battery positive voltage and connect the ground to each terminal, and then verify the operation.
-
If not as indicated in the table, replace the trunk lid latch and release actuator.