6 V6-3.7L (2009)
Front Cross-Member: Service and Repair
Front Crossmember Removal/Installation
FRONT CROSSMEMBER REMOVAL/INSTALLATION [MZI-3.7]
CAUTION:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Drain the power steering fluid.
2. Remove the steering shaft cover. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Wheel And Column
Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
3. Disconnect the steering shaft from the steering gear and linkage. See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Wheel And Column Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And
Push Button Start System]
4. Remove the steering dust cover. See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Wheel And Column
Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] See: Steering and Suspension/Steering/Steering
Column/Service and Repair/Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
5. Remove the front mudguard. See: Spoilers, Flaps, and Air Dams/Mud Flap/Service and Repair
6. Remove the front pipe. See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair
7. Remove the transverse member. See: Transverse Member Removal/Installation
8. Remove in the order indicated in the table.
9. Install in the reverse order of removal.
10. Add the power steering fluid. See: Steering and Suspension/Steering/Power Steering/Power Steering Bleeding/Service and Repair
11. Inspect the front wheel alignment. See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment
