6 V6-3.7L (2009)
4. Cut 50 mm of the end of the seat-back trim hook.
5. Re-engage the seat-back trim hook.
6. After re-engaging seat-back trim hook, turn the seat-back trim up where hook was cut off.
7. Form the end of the seat-back trim to always stay outside the side cover.
8. Recline the seat-back 5 - 6 times to make sure the end of the trim does not get caught under the side cover.
NOTE:
After this procedure, the trim will sit outside the side cover. This may look slightly different from later production vehicles, but this is normal and will
not affect any seat operation.
