6 V6-3.7L (2009)
Brake Fluid Pressure Sensor/Switch: Testing and Inspection
BRAKE FLUID PRESSURE SENSOR INSPECTION
1. Switch the ignition to off.
2. Disconnect the brake pipe flare nut.
3. Disconnect the brake hose (LF).
4. Remove the bracket.
5. Install the SSTs to the brake pipe as shown in the figure.
6. Perform air bleeding of the SST and brake line from bleeder screw A.
7. Connect the M-MDS to the DLC-2.
8. Select the "MCYLI_P" PID. See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/On-Board Diagnosis [Dynamic Stability Control (Dsc)]
9. Start the engine.
10. Depress the brake pedal, and verify that the fluid pressure value of the SST (gauge) and the value shown on the M-MDS are equal.
-
If the fluid pressure values are different, replace the DSC HU/CM. See: Hydraulic Control Assembly - Antilock Brakes/Service and
Repair/DSC HU/CM Removal/Installation
11. Remove the SSTs after the inspection and install the bracket, brake hose and brake pipe to their original positions. See: Brake Hose/Line/Service
and Repair/Brake Hose (Front) Removal/Installation
12. Perform air bleeding of the brake line. See: Brake Bleeding/Service and Repair