6 V6-3.7L (2009)
Brake Pipe Removal Note
1. Place an alignment mark on the brake pipe and DSC HU/CM.
2. Affix protective tape to the connector to prevent brake fluid from entering.
3. Remove the brake pipe.
4. Adhere protective tape to the installation area of the DSC HU/CM brake pipe to prevent foreign material penetration.
DSC HU/CM Removal Note
1. Move the DSC HU/CM component towards the inner side of the vehicle.
2. Loosen the bolt as shown in the figure.
3. Move the DSC HU/CM as shown in the figure.
4. Remove the DSC HU/CM from the DSC HU/CM Bracket.
DSC HU/CM Installation Note
1. Install the DSC HU/CM from the DSC HU/CM Bracket as shown in the figure.
2. Tighten the bolt as shown in the figure.
Tightening torque
-
4.3-6.5 Nm {44-66 kgf-cm, 39-57 in-lbf}
Brake Pipe Installation Note
1. Align the marks made before removal and install the brake pipe into the DSC HU/CM referring to the figure.
