6 V6-3.7L (2009)
Parking Brake Cable: Service and Repair
Rear Parking Brake Cable Removal/Installation
REAR PARKING BRAKE CABLE REMOVAL/INSTALLATION
1. Remove the following parts:
a. Upper panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Upper Panel
Removal/Installation
b. Shift knob (MTX) See: Transmission and Drivetrain/Manual Transmission/Transaxle/Shifter M/T/Service and Repair
c. Shift panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Shift Panel
Removal/Installation
d. Decoration panel (See See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Decoration Panel Removal/Installation.)
e. Center panel lower See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Center Panel Lower Removal/Installation
f.
Rear console See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Rear Console
Removal/Installation
2. Loosen the adjusting nut.
3. Remove the middle pipe. See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair See: Engine, Cooling and Exhaust/Exhaust
System/Service and Repair
4. Remove the insulator (middle). See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair See: Engine, Cooling and Exhaust/Exhaust
System/Service and Repair
5. Remove the floor under cover No.1 (LH) and floor under cover No.2 (RH). See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Floor Under Cover Removal/Installation
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. After installation, inspect the parking brake stroke and adjust if necessary. See: Parking Brake Lever/Testing and Inspection
