6 V6-3.7L (2009)
2. Set a wrench to the drive plate bolt at the position shown in the figure to lock the crankshaft rotation.
3. Remove the crankshaft pulley lock bolt and washer.
Crankshaft Pulley Removal Note
1. Slightly loosen the SST (49 C017 5A0) support and tilt the engine to the lower side slightly.
2. Remove the washer from the crankshaft pulley lock bolt, install a suitable spacer (thickness: approx. 14 mm {0.55 in}, diameter: approx. 30 mm
{1.2 in}), (similar to front shock absorber lower nut) to the crankshaft pulley lock bolt, and install the crankshaft pulley lock bolt to the crankshaft.
3. Remove the crankshaft pulley using the SST.
4. Remove the crankshaft pulley lock bolt and spacer.
Front Oil Seal Removal Note
