6 V6-3.7L (2009)
2. Tighten the SST nut and install the crankshaft pulley.
Crankshaft Pulley Lock Bolt Installation Note
1. Set a flathead screwdriver to the drive plate in the position indicated in the figure to lock the crankshaft rotation.
2. Tighten the new crankshaft pulley lock bolt in four steps.
a. Tighten to 140 Nm {14 kgf-m, 103 ft-lbf}.
b. Loosen 360 ° (one full turn) in reverse order.
c. Tighten to 47-53 Nm {4.8-5.4 kgf-m, 35-39 ft-lbf}.
d. Tighten 85 °-95 °.
3. Install the starter. See: Starting and Charging/Starting System/Starter Motor/Service and Repair/Removal and Replacement
