6 V6-3.7L (2009)
Driver/Vehicle Information Display: Service and Repair
Info Switch Removal/Installation
INFO SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Front scuff plate (Driver side) See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate
Removal/Installation
b. Front side trim (Driver side) See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim
Removal/Installation
c. Upper panel See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Upper Panel
Removal/Installation
d. Decoration panel (Driver side) See: Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Decoration Panel
Removal/Installation
e. Hood release lever See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release/Service and Repair
f.
Meter hood See: Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Meter Hood Removal/Installation
g. Lower panel (Driver side) See: Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Lower Panel
Removal/Installation
3. Remove the INFO switch.
4. Install in the reverse order of removal.