6 V6-3.7L (2009)
Power Steering Line/Hose: Service and Repair
POWER STEERING FLUID LINE COMPONENT REMOVAL/INSTALLATION [MZI-3.7]
NOTE:
-
The following procedure is for replacement of the parts shown in the figure.
Pressure Hose Removal/Installation
1. Remove the bolt shown in the figure, and position the power steering fluid reservoir out of the way.
2. Remove the windshield wiper arm. See: Wiper and Washer Systems/Wiper Arm/Service and Repair
3. Remove the cowl grille. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Grille Removal/Installation
4. Remove the windshield wiper motor. See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Removal and Replacement
5. Remove the cowl panel. See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair/Cowl Panel Removal/Installation
6. Remove in the order indicated in the table.