6 V6-3.7L (2009)
Engine Control Module: Programming and Relearning
PCM CONFIGURATION [MZI-3.7]
NOTE:
-
Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the PCM CONFIGURATION.
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
When using the IDS (laptop PC)
1
Select the "Module Programming".
3. Then, select items from the screen menu in the following order.
-
Select "Programmable Module Installation".
-
Select "PCM".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
-
If a DTC(s) is detected, perform the applicable DTC inspection. See: Testing and Inspection/Diagnostic Trouble Code Descriptions/DTC
Table [Engine]
