6 V6-3.7L (2009)
22. Connect short cord to original harness.
23. Tie-wrap main harness and short cord.
24. Confirm purge valve connector terminals have been correctly connected to new connector.
a. Set circuit tester to "diode mode".
NOTE:
Some circuit testers have a "diode mode (Di)". Be sure to use a tester with the red terminal on the negative side, and black terminal on the positive side
when it is set to diode mode.
b. Face bulge of connector upward, then insert red terminal into right-side and black terminal into left-side.
-
If circuit tester shows voltage is 0.5 - 0.7V, this is normal.
