6 V6-3.7L (2009)
Fuel Line Coupler: Service and Repair
Quick Release Connector Removal/Installation
QUICK RELEASE CONNECTOR REMOVAL/INSTALLATION [MZI-3.7]
WARNING:
-
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage.
Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure", while referring to the "BEFORE
SERVICE PRECAUTION".
Quick Release Connector Type
CAUTION:
-
There are two types of quick release connectors. Verify the type and location, and remove/install properly.
Type A Removal
CAUTION:
-
Be careful not to damage the pipe when unlocking the retainer.
NOTE:
-
When removing the quick release connector, either SST 49 E042 001 or 49 N013 103A (Part of 49 N013 1A0D) can be used.
When using SST 49 E042 001
NOTE:
-
If the quick release connector is removed, replace the retainer with a new one.
1. Complete the "BEFORE SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/Before Service Precaution
2. Set the SST parallel to the quick release connector.
NOTE:
-
The quick release connector can be removed by pushing the center of the retainer tabs.
-
The retainer is attached to the pipe even after the connector is disconnected.
3. Hold the center of the retainer tabs with the SST ends and press the retainer.
4. Pull the connector side and disconnect the quick release connector.
