6 V6-3.7L (2009)
5. Raise a retainer tab using the SST and remove the retainer.
6. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
When using SST 49 N013 103A (Part of 49 N013 1A0D)
1. Complete the "BEFORE SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/Before Service Precaution
2. Insert the SST into the quick release connector.
3. Pull out the fuel hose straight from the fuel pipe and disconnect it.
4. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
Type B Removal
1. Complete the "BEFORE SERVICE PRECAUTION". See: Service Precautions/Vehicle Damage Warnings/Before Service Precaution
2. Move the retainer upward using a small flathead screwdriver or a similar tool.
3. Pull out the fuel hose straight from the fuel pipe and disconnect it.
4. Cover the disconnected quick release connector and fuel pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
Type A Installation
CAUTION:
-
Always replace the retainer with a new one when using SST 49 E042 001, otherwise, fuel leakage could result.
NOTE:
-
If the quick release connector O-ring is damaged or has slipped, replace the piping component.
-
A checker tab is integrated with the quick release connector for new fuel hoses and evaporative hoses. Remove the checker tab from the quick
release connector after the connector is completely engaged with the fuel pipe.
