6 V6-3.7L (2009)
Fuel Line Coupler: Service and Repair
Quick Release Connector (Emission System) Removal/Installation
QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [MZI-3.7]
Quick Release Connector Type
CAUTION:
-
There are three types of quick release connectors. Verify the type and location, and install/remove properly.
Type A Removal
1. Release the retainer shown in the figure.
2. Disconnect the quick release connector.
3. Cover the disconnected quick release connector and evaporative pipe with vinyl sheeting or a similar material to prevent it from scratches or dirt.
Type B Removal
CAUTION:
-
Be careful not to damage the pipe when unlocking the retainer.
NOTE:
-
When removing the quick release connector, either SST 49 E042 001 or 49 N013 103A (Part of 49 N013 1A0D) can be used.
When using SST 49 E042 001
NOTE:
-
If the quick release connector is removed, replace the retainer with a new one.
1. Set the SST parallel to the quick release connector.
