6 V6-3.7L (2009)
Blind Spot Module: Component Tests and General Diagnostics
BLIND SPOT MONITORING (BSM) CONTROL MODULE INSPECTION
1. Remove the trunk end trim. See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Trunk End Trim Removal/Installation
2. Remove the rear seat cushion. See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Seat/Rear Seat Cushion Removal/Installation
3. Remove the rear side seat back. See: Body and Frame/Seats/Service and Repair/Overhaul/Rear Seat/Rear Side Seat Back Removal/Installation
4. Remove the trunk side trim.
5. Measure the BSM control module terminal voltage using the rear wiring harness connector in the position shown in the figure.
NOTE:
-
The BSM control module connector cannot be connected to a tester due to its water-resistance processing, therefore the rear wiring harness
connector is used for measuring the terminal voltage.
Terminal Voltage Table (Reference)