6 V6-3.7L (2009)
Blind Spot Module: Service and Repair
BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION
CAUTION:
-
If the BSM control modules are installed with the left and right modules reversed, a DTC will be displayed and system will enter the fail-safe
function. Therefore, confirm that the left/right BSM control modules are installed correctly.
1. Disconnect the negative battery cable.
2. Remove the rear combination light. See: Lighting and Horns/Tail Lamp/Service and Repair
3. Remove the rear bumper. See: Body and Frame/Bumper/Rear Bumper/Service and Repair/Removal and Replacement/Rear Bumper
Removal/Installation
4. Disconnect the connector.
5. Remove the nuts.
6. Remove the BSM control module.
7. Install in the reverse order of removal.
8. Perform the blind spot monitoring radar test. See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing
and Inspection/Component Tests and General Diagnostics