6 V6-3.7L (2009)
Keyless Entry Module: Programming and Relearning
Keyless Control Module Configuration [Advanced Keyless Entry And Push Button Start System]
KEYLESS CONTROL MODULE CONFIGURATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
NOTE:
-
Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the KEYLESS CONTROL MODULE CONFIGURATION.
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
When using the IDS (laptop PC)
1
Select the "Module Programming".
3. Then, select items from the screen menu in the following order.
1
Select "Programmable Module Installation".
2
Select "RKE".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
-
If a DTC (s) is detected, perform the applicable DTC inspection. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Descriptions/DTC Table [Advanced Keyless Entry And Push Button Start System]
Steering Lock Unit ID Code Registration [Advanced Keyless Entry And Push Button Start System]
STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM]
CAUTION:
-
Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:
-
M-MDS
-
Personal computer
-
Devices that can send/receive radio waves
NOTE:
-
The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock
unit.(See See: Steering and Suspension/Steering/Steering Column/Service and Repair/Steering Wheel And Column Removal/Installation [Without
Advanced Keyless Entry And Push Button Start System])(See See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System])
-
For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the
card key programming.
1. Bring the programmed advanced key into the vehicle.
2. Fully lower the driver-side door glass.
3. Connect the M-MDS to the DLC-2.
