6 V6-3.7L (2009)
21. Pull hook F in the direction shown in the figure and remove it from the body.
22. Remove the curtain air bag module.
23. Install in the reverse order of removal.
24. When the switch the ignition to ON verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection
of the system. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Flowchart
Clip A Removal Note
1. Pull out the pin to the position shown in the figure.
2. Insert a flathead screwdriver into the service hole.
3. While pulling the curtain air bag in the direction of the arrow shown in the figure, detach tabs A and B by prying with a flathead screwdriver in the
direction of the arrow.
4. Remove the clip from the body.
