6 V6-3.7L (2009)
Impact Sensor: Service and Repair
Crash Zone Sensor Removal/Installation
CRASH ZONE SENSOR REMOVAL/INSTALLATION
WARNING:
-
Handling the crash zone sensor improperly can accidentally deploy the air bags and pre-tensioner seat belts, which may seriously injure you. Read
the air bag system service warnings and cautions before handling the crash zone sensor. See: Restraint Systems/Air Bag Systems/Service
Precautions/Air Bag System Service Warnings See: Restraint Systems/Air Bag Systems/Service Precautions/Air Bag System Service Cautions
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the front bumper. See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and Replacement/Front Bumper
Removal/Installation
4. Remove the bolt A.
5. Remove the cover.
6. Remove the nut B.
7. Remove the connector.
8. Remove the crash zone sensor.
9. Install in the reverse order of removal.
10. Switch the ignition to ON.
11. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.
-
If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection
of the system. See: Restraint Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Flowchart
