6 V6-3.7L (2009)
-
If there is continuity, replace the armature.
2. Verify that there is no continuity between the commutator and the shaft using a tester.
-
If there is continuity, replace the armature.
3. Place the armature on V-blocks, and measure the runout using a dial indicator.
-
If not within the specification, replace the armature.
Starter armature runout
-
0.1 mm {0.004 in} max.
4. Measure the commutator diameter.
-
If not within the minimum specification, replace the armature.
Starter commutator diameter
-
Standard: 29.4 mm {1.16 in}
-
Minimum: 28.8 mm {1.13 in}
5. Measure the segment groove depth of the commutator.
