6 V6-3.7L (2009)
CAUTION:
-
If the oil seal (cylinder end side) drops off, the steering rack could also fall off and be damaged. Put a mat under the steering rack to protect it
from being damaged.
Seal Ring, O-ring Disassembly Note
1. Cut off the seal rings using a utility knife and remove them from the steering rack.
CAUTION:
-
Be careful not to damage the steering rack and seal ring groove in the piston when cutting off the seal ring. Otherwise, the power steering
system may not operate normally.
2. Remove the O-ring from the steering rack.
Oil Seal (pinion shaft side), Back-up Cylinder Ring Disassembly Note
1. Remove the oil seal (pinion shaft side) and the back-up cylinder ring from the gear housing using the SSTs and a press.
NOTE:
-
If they cannot be removed using only the SSTs, set an appropriate rod to the upper part of the SSTs to perform the work.
Mounting Rubber Disassembly Note
1. Remove the mounting rubber from the gear housing using the SSTs and a press.
