6 V6-3.7L (2009)
6. Tap in the oil seal (cylinder end side) to the position where the mark placed in Step 4 is lined up with the gear housing end using the SST.
7. Apply ATF to the inner surface of the cylinder end.
8. Apply thread-locking compound to three threads or more of the cylinder end and assemble the cylinder end to the gear housing.
9. Tighten the cylinder end to the specified torque using the SST.
10. Perform the cylinder air tightness inspection using the following procedure.
11. Install the SST to the power cylinder section of the gear housing.
12. Apply 53.3 kPa {400 mmHg, 15.7 inHg} of vacuum with a vacuum pump and verify that it holds for 30 s.
-
If there is a malfunction, inspect the gear housing inner surface and the oil seal, and the O-ring and seal ring for damage, and repair or replace
if necessary.
Oil Seal Assembly Note
1. Using the SST and press, assemble the oil seal to the valve housing.
