6 V6-3.7L (2009)
NOTE:
-
Assemble the oil seal groove area so that it is facing the gear housing.
Substitution SST
-
49 T032 302
Outer diameter: 27-30 mm {1.07-1.18 in}
Bush Assembly Note
1. Assemble the bush to the valve housing using the SST and a press.
Substitution SST
-
49 G030 160
Outer diameter: 28-32 mm {1.11-1.25 in}
Wave Washer and Oil Seal Assembly Note
1. Wrap vinyl tape around the pinion shaft from the notch area of the pinion shaft as shown in the figure, and apply ATF to the surface.
2. Apply ATF to the oil seal and assemble the wave washer and oil seal to the pinion shaft.