6 V6-3.7L (2009)
Control Arm: Service and Repair
Front Lower Arm Removal/Installation
FRONT LOWER ARM REMOVAL/INSTALLATION
CAUTION:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove the aerodynamic under cover No.2. (L5) See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.2
Removal/Installation
2. For the vehicle with MZI-3.7, working on the right side of the vehicle, remove the front pipe. See: Engine, Cooling and Exhaust/Exhaust
System/Service and Repair
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Inspect for front wheel alignment. See: Alignment/Service and Repair/Front Wheel Alignment
