6 V6-3.7L (2009)
5. Perform the N position learning according to the directions on the screen.
-
When "Operation Successful" is displayed, shift the selector lever to the P position and switch the ignition to off, then to ON after 5 s.
-
If "Reinstall TCM properly and then try again" is displayed, perform the following inspection:
-
Verify that the transaxle manual shaft is in the N position.
-
If the manual shaft is in a position other than N, shaft it to the N position.
-
Verify that the selector cable is adjusted properly.
-
If the selector cable is not adjusted properly, adjust it. See: Shift Linkage/Shift Cable/Adjustments
-
Inspect the manual shaft lever for deformation.
-
If there is any malfunction, replace the manual shaft lever.
6. Shift the selector lever from P position to D range, then verify that the positions of the selector lever and the indicator are aligned.
-
If there is any malfunction, inspect the DTC. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Descriptions/DTC Table [AW6A-EL]