6 V6-3.7L (2009)
Seals and Gaskets: Service and Repair
Differential Gear O-Ring Replacement [AW6A-EL]
DIFFERENTIAL GEAR O-RING REPLACEMENT [AW6A-EL]
CAUTION:
-
The O-ring is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the O-ring.
1. Remove the drive shaft and joint shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Joint Shaft Removal/Installation See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Drive Shaft Removal/Installation
CAUTION:
-
Do not damage the differential case.
2. Remove and discard the O-ring using a tape-wrapped flathead screwdriver.
CAUTION:
-
Do not damage the O-ring.
-
Do not damage the differential case.
3. Apply ATF to a new O-ring and install it to the differential case.
4. Install the drive shaft and joint shaft. See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Joint Shaft Removal/Installation See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Removal and
Replacement/Drive Shaft Removal/Installation
