6 V6-3.7L (2009)
10. Using snap ring pliers, install the snap ring and confirm proper fit.
11. Clean excess ATF from bottom of transmission.
12. Lower the vehicle.
13. Refill ATF with drained oil from step 4.
14. Start engine and shift from "P" to "D" range two times and allow engine to warm up.
15. Check oil level with ATF dip stick using a new nylon cloth to prevent contamination. If additional fluid is required, use ATF JWS3309 to top off.
16. Verify repair by inspecting A/T servo cover and drain plug after test drive.
17. Install the under cover.
PART(S) INFORMATION
