mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Input/Turbine Speed Sensor Removal/Installation [FS5A-EL]|Page 3729 > < Input/Turbine Speed Sensor Removal/Installation [FS5A-EL]|Page 3727
Page 1
background image

Transmission Speed Sensor: Service and Repair
Input/Turbine Speed Sensor Removal/Installation [AW6A-EL]

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [AW6A-EL]

WARNING:

-

A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until then are cool.

1. Remove the control valve body. 

a. Disconnect the negative battery cable.

b. Remove the air cleaner component.  See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair

c. Remove the air cleaner bracket.

d. Remove the TCM.  See: Control Module/Service and Repair/TCM Removal/Installation [AW6A-EL]

e. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.

f.

Drain the ATF.  See: Service and Repair/Removal and Replacement/Automatic Transaxle Fluid (ATF) Replacement [AW6A-EL]

g. Disconnect the oil hose from the transaxle.

h. Remove the oil pipe.  See: Transmission Cooler/Service and Repair/Removal and Replacement/Oil Cooler Removal/Installation [AW6A-EL]

i.

Remove the control valve body cover.

j.

Remove the control valve body.  See: Valve Body/Service and Repair/Removal and Replacement/Control Valve Body Removal/Installation
[AW6A-EL]

2. Remove the input/turbine speed sensor.

3. Install the input/turbine speed sensor. 

Tightening torque

-

3.9-6.9 Nm {40-70 kgf-cm, 26-60 in-lbf}

4. Install the control valve body.  See: Valve Body/Service and Repair/Removal and Replacement/Control Valve Body Removal/Installation

[AW6A-EL]

5. Remove the control valve body cover.

6. Install the oil pipe.  See: Transmission Cooler/Service and Repair/Removal and Replacement/Oil Cooler Removal/Installation [AW6A-EL]

7. Connect the oil hose to the transaxle.

8. Add ATF.  See: Service and Repair/Removal and Replacement/Automatic Transaxle Fluid (ATF) Replacement [AW6A-EL]

9. Install the TCM.  See: Body and Frame/Splash Guard/Service and Repair/Aerodynamic Under Cover No.1 Removal/Installation

10. Remove the air cleaner bracket.

11. Install the air cleaner component.  See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair

Input/Turbine Speed Sensor Removal/Installation [FS5A-EL]|Page 3729 > < Input/Turbine Speed Sensor Removal/Installation [FS5A-EL]|Page 3727