6 V6-3.7L (2009)
2
Pry the screwdriver in the direction of the arrow and disconnect the connector.
CAUTION:
-
Do not damage the solenoid valves and connectors with the screwdriver.
-
When disconnecting connectors, grasp the connectors, not the harnesses. Otherwise, the harnesses may be pulled out of the connector causing
poor contact.
11. Disconnect the solenoid connectors, VSS connector and the input/turbine speed sensor connector.
12. Disconnect the coupler component from the clamp.
13. Remove the lock plate, and pull out the TFT sensor from the control valve body.
14. Remove the O-ring from the TFT sensor.
NOTE:
-
Be sure to secure the coupler component with tape so that it will not interfere with the control valve body component.
