6 V6-3.7L (2009)
^
Some vehicles may have additional foam padding (A). If this is the case, peel off both A and B padding.
6.
Install a new (3 x 20 x 40 mm) foam pad from kit in same location as removed padding from Step 5 (without gap between foam and lip). Proceed
to Step 7.
NOTE:
Kit includes four (4) pads, but only one (1) or two (2) are used for this repair.
7.
Install a second (3 x 20 x 40 mm) foam pad from kit over top of confirmed pad in Step 5 (or first installed pad in Step 6).
NOTE:
^
Kit includes four (4) pads, but only one (1) or two (2) are used for this repair.
^
If a foam pad of a different thickness is used, wind noise may become worse. Be sure to use only the 3 x 20 x 40 mm size padding from the
kit.
8.
Reinstall glass run channel.
