mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

A/C - Insufficient Cooling Performance|Page 4071 > < A/C - Decreased Cooling, Low Air Flow from Vents|Page 4066
Page 1
background image

Ambient Temperature Sensor / Switch HVAC: All Technical Service Bulletins
A/C - Insufficient Cooling Performance

Category 16
Applicable Model/s 1986-1987 626
Subject

EVAPORATOR FREEZE-UP
Bulletin No.. 015/86
Issued

10/3/86

Revised

10/22/86

Evaporator

DESCRIPTION

Some reports have been received regarding the A/C evaporator on 626 vehicles which "freezes-up" and causes insufficient cooling performance. In most
cases, this condition is caused by a defective thermistor and/or a thermistor that is incorrectly installed in the evaporator. If a customer complains about
insufficient cooling performance, follow the procedures below in order to diagnose and repair evaporator freeze-up vehicles.

REPAIR PROCEDURES

1.

Diagnosis

If the following conditions occur on the vehicle, which may be caused by the evaporator freeze-up, proceed to Step 2.

^

Insufficient cooling from center louver.*

^

Compressor does not cycle properly. (Magnet clutch is engaged all the time.)

^

Air volume from vents is reduced noticeably.

The revised section is indicated by an asterisk. Please replace the original Service Bulletin with the revised bulletin.

A/C - Insufficient Cooling Performance|Page 4071 > < A/C - Decreased Cooling, Low Air Flow from Vents|Page 4066