626 L4-2000 1970cc (1982)
Carburetor Float: Adjustments
Float Level Adjustment
1.
With the engine operating, check the fuel level in the fuel bowl sight glass, if equipped.
2.
If the fuel level is not to the specified mark in the sight glass, remove the carburetor from the vehicle.
3.
Remove the fuel bowl sight glass.
4.
Invert the carburetor on a stand and allow the float to hang by its own weight.
5.
Measure the clearance between the top of the float and the air horn gasket surface. If clearance is not within specifications, bend the float seat lip
until the proper clearance is obtained.
6.
Turn the carburetor to the normal position and allow the float to hang by its own weight.
7.
Measure the clearance between the bottom of the float and the air horn gasket surface. If the clearance is not within specifications, bend the float
stopper until the proper clearance is obtained.
8.
Install the fuel bowl sight glass.
9.
Install the carburetor to the engine.
10.
Operate the engine and make sure that the fuel level is to the specified mark in the sight glass.
