626 L4-2184cc 2.2L SOHC F2 (1989)
1.
If water is collecting in storage wells, check drain holes for dirt or undercoating.
Note:
Do not seal up drain holes at the bottom of the storage wells.
2.
Check for any leaks at the grommet and plug between the quarter panel and bumper. Examine seems for missing sealer or pin holes. Seal any
suspected defects. Figures 26 and 27.
3.
Check for any leaks at the fuel filler neck-to-body in the left quarter. If moisture is present, remove the filler neck.
4.
Apply sealer to both sides of the gasket and reinstall.
AREA D:
INNER WHEEL WELL-TO-FLOOR PAN (UNDER REAR SEAT) AND INSIDE THE ROCKER PANELS
1.
Remove rear seat bottom and lift carpet.
2.
Check for any leaks due to pin holes or missing sealer along the inner wheel well-to-body seam.
3.
Remove the plastic sill plates and confirm that there is no water being retained inside the rocker panel.
4.
If water is present, seal the inner wheel well-to-rocker panel seam.
AREA E:
KEY LOCK CYLINDER
1.
If the leak occurs at the key lock cylinder, remove or replace gasket.
2.
After installing the gasket, seal around the key lock cylinder-to-deck lid area from the inside with silicone.
Location IV
LOCATION IV:SUNROOF OR HEADLINER AREA
Location of Water Leak Source
1.
Have an assistant help locate the exact point of water entry.