mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Engine - Low, Rough Idle, Vibration in DRIVE|Page 2187 > < Engine - Low Rough Idle, Vibration in DRIVE|Page 2182
Page 1
background image

Radiator: All Technical Service Bulletins
Engine - Low, Rough Idle, Vibration in DRIVE

Category       

Applicable Model/s

1

1988-'89 626/MX-6

ATX

Subject IDLE VIBRATION IN "D" RANGE
Bulletin No. 042/89
Issued

7/19/89

Revised
DESCRIPTION

Excessive vibration may be felt in the steering wheel and seats while idling in "D" range, especially when electrical loads are applied. For proper repair
procedures, please refer to the instructions in this Service Bulletin.

Please note that the customer may also describe this complaint as a low or rough idle and not necessarily complain of vibration.

Therefore, confirm the customer complaint carefully before attempting any repair.

PRODUCTION CHANGE

No. 1 Engine Mount and Radiator Lower Mount Rubbers have been changed as follows:

^

No. 1 Engine Mount

^

The diameter of the rubber has been increased from 3.15 in. to 3.54 in. since the November 1988 production.

^

The rubber has been turned 10~ toward the engine side since the November 1988 production.

BEGINNING VIN OF PRODUCTION CHANGE

A.

No.1 Engine Mount

For vehicles produced in Japan:
1989 626/MX-6

JM1GD**** K1725513

October 1, 1988

For vehicles produced in the U.S.A:
1989 MX-6

1YVGD**** K5213922

November 9, 1988

B.

Radiator Lower Mount

For vehicles produced in Japan:
1989 626/MX-6

JM1GD**** K1769601

June 1, 1989

For vehicles produced in the U.S.A:
1989 MX-6

1YVGD**** K5245888

June 24, 1989

Engine - Low, Rough Idle, Vibration in DRIVE|Page 2187 > < Engine - Low Rough Idle, Vibration in DRIVE|Page 2182