626 L4-2184cc 2.2L SOHC F2 (1989)
Engine Mount: Customer Interest
Engine - Low Rough Idle, Vibration in DRIVE
Category B
Applicable Model/s 1988-90 626/MX-6 ATX
Subject IDLE VIBRATION IN "D" RANGE
Bulletin No. 001/90 Issued 4/20/90 Revised
NOTE:
No. 1 and no. 2 engine mounts, which are more effective for this subject matter, are now available as service parts only for field complaints. The
mass-production change and field countermeasure were explained in Service Bulletin, Category 1 no. 042/89. When you encounter a customer complaint
regarding the following description, please handle it in accordance with this bulletin.
DESCRIPTION
Excessive vibration may be felt in the steering wheel and seats while idling in "D" range, especially when electrical load is applied. For the proper repair
procedure, refer to the instructions in this Service Bulletin.
Please note that the customer may also describe this complaint as a low rough idle and may not necessarily complain of vibration. Therefore, confirm the
customer complaint carefully before attempting any repair.
PRODUCTION CHANGE
No. 1 engine mount and radiator lower mount rubbers have been changed as follows:
^
No. 1 Engine Mount
a)
The diameter of the rubber has been increased from 3.15 in. to 3.54 in. since the November, 1988 production.
b)
The rubber has been turned 10~ toward the engine side since the November, 1988 production.
^
Radiator Lower Mount
a)
Changed since June, 1989 production.
PARTS INFORMATION
FIELD COUNTER
MASS-PRODUCTION
DESCRIPTION
APPLICABLE
MEASURE PART
PART
MODELS
*GNYl 39 040
M002 39 040A
# 1 Engine Mount
ATX w/o Turbo
*GNY2 39 040
GJ28 39 040D
# 1 Engine Mount
ATX w/ Turbo
