626 L4-2184cc 2.2L SOHC F2 (1989)
Green label) of the pressure regulator.
4)
Install the solenoid valve onto the solenoid bracket.
Installation of Wire Harness
2.
Installation of Wire Harness (with & without Turbo)
A.
Under Dashboard
1)
Install the control unit from the kit to lower left side of the E.C.U. (Emission Control Unit).
2)
Connect the single couplers (Black & Blue) from the wire harness of the kit.
3)
Connect the wire harness to the control unit.
4)
Connect the 2 ends of the wire harness of the E.C.U. at DEM-01.
5)
Install the ground wire with bolt (# 10) and tighten it.
6)
Fasten the wire harness with bands.
7)
Pass the 3 ends of the wire harness through the rubber seal in the firewall.
