626 L4-2184cc 2.2L SOHC F2 (1989)
Solenoid Purge Valve
1.
Remove the solenoid valve.
Purge Control Soleniod Test -- Voltage Applied
2.
Connect vacuum hoses to the valve as shown in the figure.
3.
Blow air through the valve from hose "B" and check that air comes out of the valve air filter.
4.
Apply 12V and ground the solenoid valve with jumper wires.
5.
Blow air through the valve from hose "B" and check that the air comes out of port "A".
6.
Replace, if necessary.
Three Way Check Valve
CHECK AND CUT VALVE
1.
Remove the check and cut valve.
Check And Cut Valve Testing
2.
Connect a pressure gauge to the passage that normally is connected to the fuel tank.
3.
Blow through the valve from port "A". Verify that the valve opens at 0.98-4.91 kPa (0.01-0.05 kg/sq cm 0.14-0.71 psi).
4.
Remove the pressure gauge and connect it to the passage to atmosphere.
