626 V6-2496cc 2.5L DOHC (1995)
Overdrive Off Switch: All Technical Service Bulletins
A/T Overdrive Switch - Inoperative
Bulletin No.: 003/95
Issued: 10/17/95
Revised
Category
K
Applicable Model/s
1993-95 626 / MX-6
Subject
BROKEN "HOLD" or "O/D" SWITCH WIRE
APPLICABLE MODELS
All 1993 - 95 626 and MX-6 vehicles with Automatic Transaxles
DESCRIPTION
The "HOLD or "O/D" function will not work and/or the light (indicating either function) may not illuminate. This can be caused by a broken wire
connected to the shift lever. Breakage occurs when the wire is pinched at the base attaching clip and broken when the shift lever is moved. Customers
complaining of this problem should have the vehicle inspected and repaired using the instructions below.
REPAIR PROCEDURE
1.
Verify the complaint
2.
Remove front console.
3.
Inspect the wire for no or intermittent continuity when the wire is wiggled.
Refer to HOLD or O/D Switch Inspection of Continuity Procedures in section K of the workshop manual.
^
If no continuity exists, the wire is probably broken. Proceed to step 4.
^
If continuity exists, refer to the workshop manual for troubleshooting instructions.
4.
Inspect the wire where it attaches to the clip.