626 V6-2496cc 2.5L DOHC (1995)
Throttle Position Sensor: Service and Repair
REPLACEMENT
1. Disconnect the throttle position sensor connector.
2. Remove the attaching screws.
3. Remove the throttle position sensor.
4. Verify that the throttle valve is fully closed.
5. Open the throttle valve slightly and catch the tang of the throttle body on the throttle position sensor plastic tabs. Align tang A on throttle body
with tab A on throttle position sensor. Note tangs on the throttle body mate with the tab on the throttle position sensor on the side of the tab
without a slot.
6. Position the throttle position sensor on the throttle body so that the mounting holes align.
7. Release the throttle.
8. Adjust the throttle position sensor output voltage and idle switch.